Adjusting The Idle Speed; Handlebar; Rear Shock Absorber; Adjusting The Spring Preload - Beta Motorcycles ALP 200 Bedienungsanleitung

3

ADJUSTING THE IDLE SPEED

The slow running should be adjusted when
the engine is hot. Connect an electronic
revolution counter to the spark plug ca-
ble. Then use a screwdriver on register
screw 1 to calibrate the minimum with
1600÷1700 rpm
1

HANDLEBAR

1
The handlebar can be adjusted by rotating
it back and forth.
- To adjust the handlebar loosen screws 1
- Position the handlebar according to
requirements.
20Nm
- Tighten to the torque indicated.

REAR SHOCK ABSORBER

ADJUSTING THE SPRING PRELOAD

To adjust the spring preload, use the
procedure described below. Rotate ring
clockwise to increase the spring preload
(and consequently the shock absorber
preload) or anticlockwise to decrease it.
GB
33