Headlight; Replacing The Headlight Bulbs - Beta Motorcycles ALP 200 Bedienungsanleitung

4
1
4
3
GB

HEADLIGHT

Keep the headlight glass clean at all times
(see page 53).
Periodically check the correct angle of the
light beam (chapter 3).
REPLACING THE HEADLIGHT
BULBS
• Remove the two screws 1 and 2 that
secure the light unit to the light holder.
• To replace the position light, remove bulb
holder 3.
1
2
To replace the low/high beam light:
• disconnect the electric connector 4.
• lift the rubber casing 5.
5
• release the spring 6.
• Remove the bulb from the connectors and
carry out replacement.
To refit, follow the procedure above but in
reverse order.
5 When carried out the replacement perform
the adjustment (page 34).
6
48