Removal - Beta Motorcycles ALP 200 Bedienungsanleitung

4

REMOVAL

Remove the saddle, the tank cover and the
2 3
undersaddle plastic shield, as described
in "Body disassembly and reassembly" on
page 58 .
Remove the cover 2 by loosening the
screw 3.
Release rubber band.
FIRST disconnect the negative connector
(black) from negative (-) pole and THEN
positive connector (black) from negative
(+) pole.
Remove the battery.
When fitting the battery, insert it with the
terminals as shown in picture.
FIRST connect the positive connector (red)
from positive (+) pole and then negative
connector (black) from negative (-) pole.
WARNING:
Exercise extreme caution if, for any reason,
the electrolyte (sulphuric acid) should come
out of the battery. The electrolyte can cause
serious burns. In case of contact with the
skin, rinse abundantly with water.
Should the electrolyte come into contact
with the eyes, rinse with water for at least
15 minutes and immediately seek medical
attention.
Even though the battery is sealed, there
is a possibility that explosive gases may
leak out.
Keep sparks and open flames away from
he battery.
Keep spent batteries out of the reach of
children and dispose of them as prescribed
by law.
Do not remove the protections.
When installing the battery, be sure to
observe the polarity of the terminals.
GB
50