Clutch Control; Rear Brake Lining Control - Beta Motorcycles ALP 200 Bedienungsanleitung

4

REAR BRAKE LINING CONTROL

2 mm
In order to verify the wear condition of rear
brake is enough to view the caliper from
the back side, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let's start replacing them.
NOTE:
Perform the check according to the times
shown in the table on page 55.
To replace, contact authorised Betamotor
customer service.

CLUTCH CONTROL

2
Adjust the lever 1 by means of the reg-
ister 2, lift rubber dust cover 3 and turn
adjuster 2.
The lever must have 4-5 mm of idle stroke.
1
3
GB
44