Headlight - Beta Motorcycles ALP 200 Bedienungsanleitung

3
1
GB
2
10 m
34

HEADLIGHT

•The beam is adjusted by loosening the
left and right fixing screws 1 of the mask
and changing the inclination of the opti-
cal unit by turning the screws 2.
•Place the vehicle on level ground (but
not on the stand) 10 metres from a verti-
cal wall.
•Measure the height of the headlight cen-
tre above the ground and then draw a
cross on the wall at 9/10 of the height
of the headlight centre.
•Turn on the low beam, get on the motor-
bike and check that the headlight beam
on the wall is slightly lower than the cross
drawn previously. Where this is not the
case, proceed to adjustment.
•Periodically check the direction of the
beam. The beam can only be adjusted
vertically.