gefran 1200 Bedienungsanleitung Seite 58

0VT
Outputs Settings
This menu is used to configure the type of Alarm 1 and the Output 2 cycle time.
v
0 t
PV
---
SV
AI. t
PV
Alarm type 1
0
SV
If more alarms are
enabled *, please set
them using the same
table
* (A2t, A3t).
r OUT 1
L. 1
PV
Allocation of reference signal
2
SV
If more outputs are available *, please
set them using the same table
* (rL2, rL3, rL4)
Gt. 2
PV
20
OUT 2 Cycle time (HEAT or COOL)
SV
[1 ... 200] sec.
the same setting range is valid also for
Ct1, Ct3, Ct4.
Second menu to set up
A A 1 1 . . T T
By adding the following amounts to the values shown in
the table a series of supplementary functions can be
enabled
+8: to disable on power up until first interception.
+16: to enable alarm memory.
+32: KY. 1 menu [FG = alarm trigger delay time
+64: KY. 1 menu [FG = alarm trigger delay time
R R L L . . 1 1 ; R R L L . . 2 2
R R L L . . 3 3 ; R R L L . . 4 4
Add +32 to the values indicated in the table to obtain the denied
logic level in output, except for codes 0..1 with continuous output
64 *
(0.1 ... 20.0 sec.)
65 *
only for RL. 3 o RL. 2 if continuous OUT3 is not present
*)
58
Direct
(high limit
Inverse Absolute/Relative
(low limit) to active Setpoint
0 Direct Absolute
1 Inverse Absolute
2 Direct Relative
3 Inverse Relative
4 Direct Absolute
5 Inverse Absolute
6 Direct Relative
7 Inverse Relative
([0..999] sec. (excluding absolute symmetric)
([0..999] min. (excluding absolute symmetric)
Function
0 HEAT (control output for heating)
1 COOL (control output for cooling)
2 AL1 – alarm 1
3 AL2 – alarm 2
4 AL3 – alarm 3
5 AL. HB – HB alarm
6 LBA – LBA alarm
7 IN – repetition of logic input 1
8 Repeat but key (if BVT menu KRD = 8)
9 AL1 or AL2
10 AL1 or AL2 or AL3
11 AL1 And AL2
12 AL1 and AL2 and AL3
13 AL1 or AL. HB
14 AL1 or AL2 or AL. HB
15 AL1 and AL. HB
16 AL1 and AL2 and AL. HB
RL. 2 HEAT: heat control output with fast cycle time
RL. 3 HEAT: continuous output 2 – 10 V
RL. 2 COOL: cool control output with fast cycle
time (0.1 ... 20.0 sec.)
RL. 3 COOL: continuous output 2 – 10 V
-Easy-
Normal
Symmetric
(window)
Normal
Normal
Normal
Normal
Symmetric
Symmetric
Symmetric
Symmetric