elmeg CS290 Bedienungsanleitung Seite 79

• All phone calls are signaled. No number (MSN) has been entered in the telepho-
ne.
Dialing of outgoing calls is possible after lifting the handset (no call preparation, no
•
open listening).
Downloading a new firmware via the IDSN port.
•
Downloading new firmware via the ISDN port
S
You are shown the BIOS menu for the tele-
phone.
If you wish to load new firmware via the
ISDN connection, press the softkey »UP-
DATE«.
Now proceed as explained on page 34 of these operating instructions.
Attention: The settings for the softkey »SET« are used for service and diagnosis at
elmeg. Any settings you may make or modify in this menu will affect the overall
functionality of your telephone. In some cases the telephone may not be able to be
used if these settings are changed.
RESET - Resetting to default state
You can reset the telephone to its initial state using the procedure described as follows.
All of the data that you have entered previously will be deleted.
Begin as follows:
F
a
S
Press the softkey below »ok« to reset the
telephone to its initial state. If you do not
wish to have the data deleted press the
softkey below »no«.
The telephone is reset to its initial state. All
data are deleted.
S >
config
35
ˆCS290-bios 1.03 by ps
ˆINFO SET
S S
service data
ˆ Sure to delete all?
ˆ no
ˆ17.02.02 08:30
ˆ tbook vip
UPDATE
ok
}