Call Charges - elmeg CS290 Bedienungsanleitung

Call charges

You must apply for this feature at your network service provider. Transmission of the
current charges can, depending on the service you applied for, be displayed either du-
ring or after the call.
Please note that only charge billing by the network service provider is binding.
Setting the charge factor (charge rate factor)
The setting of the charge factor can have a maximum of 4 digits. To enter a comma, use
*
the key.
In the menu »charges« (see figure 2 on page 7) press the softkey »charge«.
t
Enter the new charge factor.
In this example: »0,25«.
O
Confirm your entry by pressing OK.
Resetting the charge display
There are several standardized procedures for transmitting call charge rates. Usually the
same procedure is employed at one connection that is recognized and stored automati-
cally for future use by the telephone. In the event that the phone receives charge infor-
mation that is not stored, »wrong charge type« then appears in the display.
When the charges that are stored in the phone are deleted, recognition and saving are
reactivated automatically.
In the menu »charges« (see figure 2 on page 7) press the softkey »delete«.
S
Press the softkey »no«, if you do not want
to reset the type of charge information. If
you want to delete the charge information,
press the softkey »ok«.
Setting the currency
The entry for the name of a currency can have a maximum of 6 digits. For a description
on how to enter characters, please refer to page 5.
In the menu »charges« (see figure 2 on page 7) press the softkey »currency«.
t
Enter the new currency.
In this example: »CUR«.
O
Confirm your entry by pressing OK.
ˆ Amount for units
ˆ>0.25_
ˆ
ˆ no
ˆ Currency name
ˆ>CUR_
10
Reset charge type?
ok