User Interface Of The Telephone - elmeg CS290 Bedienungsanleitung

User interface of the telephone

1 Function Key: This key opens the programming menu. If you are already loca-
ted in a menu and then press the key, either menu-specific functions are
shown, or you are moved back one programming step.
2 Escape button: Pressing the Esc button during programming returns the tele-
phone to its idle status.
3 3 Softkeys
The functions of the softkeys are displayed in capital or small letters (depen-
ding on your settings).
4 Display: After you connect the system to the internal ISDN port of the pabx, the
date and time are shown on the top line of the display. The date and time are
imported automatically from the pabx. The text displayed for a function on line
2 is always located above the corresponding softkey. When you press the soft-
key, the next level is displayed.
If not all information fit into the screen, this will be indicated by »«« or »»«.
5 OK button: Pressing this button stores a setting in the telephone. You then
hear the acknowledgement signal.
6 C-button: Press this button to move back one menu step in the menu. If you
are currently in the input mode, this button can be used to delete individual
characters.
7 Incoming call LED: Incoming calls are signaled by a rapidly flashing LED.
8 Speaker
9 Open listening
10 Ending a call
11 Enquiry button
12 Redial button
13 Arrow keys: The arrows »{« and »}« in the right corner on the top line of the dis-
play indicate that you can call up further functions on the lower lines using the
arrow buttons.
14 asterisk key, rhombus key
15 Dial keys / VIP keys
16 Five programmable function keys with inset LED:
Each button has an LED assigned to it. These LEDs can be used to indicate
certain functions.
The LEDs of the two keys at the bottom have two different colors.
17 Label panel for programmable function keys
III