Operation - elmeg CS290 Bedienungsanleitung

Operation

Important notes
Not all of the performance features described here are implemented in the ISDN stan-
dard connection or in the pabx. Contact your service provider to determine how or if you
must apply separately for the individual performance features for your ISDN connection.
If the ISDN telephone is disconnected from the ISDN network, (e.g.by unplugging the
ISDN connector of the phone or by switching off or resetting the pabx), several settings
and lists will be lost.
Z.B.: Temporarily stored text messages (SMS, UUS1), a requested Call-Back on busy or
data downloaded from the pabx.
Starting a call
Dial number - no correction possible
b t
Dial number
Dial number - correction possible
a t
Dial number
To change the number or to correct a wrong entry, select the wrong figure with the arrow
C
buttons and press
If you wish to conduct the call using the handset, just lift it up after dialing the number.
Any time during a call you can switch back and forth between speaker function and use
of the handset.
After you have dialed the number you can also press the speaker button to have the
number dialed.calling. Once the called party has answered the call, just lift up the hand-
set.
If a call can not be put through because the number is inhibited via the calling filter, the
following message will appear in the display »Inhibit.: ext. number«.
Other options for dialing without lifting the handset
The option of dialing without lifting the handset and of correcting or adding to a number
also exists during dialing:
from the redialing memory (see page 19).
•
from the caller list (see page 20).
•
• from the VIP memory (see page 14).
g
b g
to delete it.
16