elmeg CS290 Bedienungsanleitung Seite 53

Display the call number
Display the number for the called party (CLIP/CLIR)
To have your own number displayed at the party you are calling press the softkey»ok«. If
you do not wish to have your number displayed at the party you are calling press the
softkey »no«.
In the menu »call-number transfer« (see figure 2 on page 7) press the softkey
»outgoing«.
S
Press the softkey below »no« or »ok«.
Display of number at caller (COLP/COLR)
To have your phone number displayed at the party you are calling press the softkey
»ok«. If you do not wish to have your number displayed at the party you are calling press
the softkey »no«.
In the menu »call-number transfer« (see figure 2 on page 7) press the softkey
»incoming«.
S
Press the softkey below »no« or »ok«.
Not all of the performance features described here are implemented in the ISDN
standard connection or in the pabx. Contact your service provider to determine
how or if you must apply separately for the individual performance features for your
ISDN connection.
Display during call
Call display for phone number (»0123456«) and char-
ges (»0,36«).
Correct charge display is shown only if you have applied at your network service
provider for transmission of charges during calls.
Please note: When using an LCR procedure the charges are not registered proper-
ly, as they are not transmitted by all providers.
Call display for phone number (»0123456«) and du-
ration (»02.19«) of entire call.
ˆ Called subscriber numb?
ˆ no
ˆCalled suscriber number?
ˆ no
ˆ0123456
ˆ
ˆ0123456
ˆ
9
ok
ok
0.36
silent keypad
02.19
silent keypad