elmeg CS290 Bedienungsanleitung Seite 52

Setting the call signaling melody and volume
You can define and set a specific melody and its volume for each MSN or extension
number that you enter. If you are using the telephone at an internal ISDN connection, you
can program special ringing melodies and a different volume for internal calls.
In the initial setting of the telephone, 10 different melodies are stored for call signa-
ling. These 10 melodies can not be changed.
Setting the melody
In the menu »MSN-1 program« (see figure 2 on page 7) press the softkey »sound« and
then the softkey »internal« or »external«.
<>
Use the arrow buttons to set the desired
O
tone (melody).
Confirm your entry by pressing OK.
Setting the melody volume
In the menu »MSN-1 program« (see figure 2 on page 7) press the softkey »volume«
and then the softkey »internal« or »external«.
<>
Use the arrow buttons to set the desired
O
volume.
Confirm your entry by pressing OK.
Assigning a name to the MSN
You can assign your own names (max. 5 characters) to the MSN extension numbers.
The assignments for the keypad for entering letters and digits are described on page 5.
In the menu »MSN-1 program« (see figure 2 on page 7) press the softkey
»msn-name«.
t
Enter the name desired name.
In this example: »STORE«.
O
Confirm your entry by pressing OK.
Once a name has been entered for a number, the softkey designations »msn-1«,
»msn-2« or »msn-3« are replaced by the corresponding names in the menu. IIn this ex-
ample here the name »STORE« is displayed instead of »msn-1«.
ˆ Select melody
ˆ -©--------
ˆ Select call signal
ˆMSN-1
ˆ Own MSN designation
ˆMSN-1>STORE
8
{}
2
{}
- ©©©--- +