elmeg CS290 Bedienungsanleitung Seite 56

F
Press the button. Use the arrow buttons to set the volume as desired.
E
Press the button in order to return to the normal display during an ongoing call. If
you confirm your entry by pressing the
manently set value is overwritten by the newly set one.
Setting the acknowdledgement signals
With your telephone you can select whether the acknowledgement signals are always
active (»ok«), never active (»no«) or only active when an incorrect entry is made (»er -
ror«). The default setting has the acknowledgement signal always active.
In the menu »Volume,etc.« (see figure 3 on page 11) press the softkey »beep«.
S
Press the softkey below the desired functi-
on.
Positive acknowledgement signal
(1 long beep):
Negative acknowledement signal
(3 short beeps):
Setting the call waiting signal
If the function call waiting (see page 15) is enabled on your telephone you can set the vo-
lume of the call waiting signal. You can also select whether a waiting call is signaled only
once, or several times.
In the menu »Volume,etc.« (see figure 3 on page 11) press the softkey »repeat«.
S
If you want the waiting call to be signalled
only once, press the softkey below »no«.
To have a waiting call signalled several ti-
mes, press the softkey below »ok«.
n the menu »Volume,etc.« (see figure 3 on page 11) press the softkey »volume«.
<>
Use the arrow buttons to set the volume of
O
the call waiting signal.
Confirm your entry by pressing OK.
O
button instead of the
ˆAcknowledge signal activ
ˆ
Your entry has been received and stored by the
phone.
Incorrect input not accepted by the phone. The
desired action cannot be carried out.
ˆ
ˆ
ˆ Call wait. tone vol. {}
ˆ
12
E
button, the per-
no error ok
Repeat call wt. tone?
no ok
- ©©©--- +