Accepting A Call - elmeg CS290 Bedienungsanleitung

Accepting a call

In its initial state the telephone will accept all calls, regardless of the service and dialed up
MSN extension number. If two calls are signaled simultaneously the first one is accepted
when you lift the handset. The second call is then no longer signaled or indicated in the
display. The second caller will then hear the busy signal.
The telephone number of the caller is shown on the first line in your display. The second
line shows on the right the MSN extension number or the name (»msn-1«...»msn-3«)
that the caller has dialled.
a l
No number transmission
When a call is signaled, you can decide before accepting the call whether your number is
to be transmitted to the caller. If your phone is the final destination of call rerouting you
can use this procedure to prevent the caller from seeing the final destination phone num-
ber (i. e. yours). You can set this function specifically for the next call, or permanently (see
page 9).
a l
Rerouting / rejecting a call
If you are unable, or do not wish to accept a call, you have the option of rejecting or for-
warding this call. To do this, press the softkey below »reject«. The calling party hears
the busy signal.
Press the softkey below »x-fer« to forward the call to a different subscriber.
Rejecting
a l
Call Deflection
a l
b g
> S
Concealed
S
reject
S
t
x-fer Dial number
18
b g
O