B) Programming The Speed Controller - Reely Mini Mono Bedienungsanleitung

b) Programming the Speed Controller

• Switch on the transmitter. Pull the throttle lever into the full throttle position and hold it there.
• Connect the drive battery to the speed controller (the throttle lever at the transmitter is still in the full throttle position).
First, there are two short signal sounds, followed by a short melody (signal sounds) after five seconds. The speed
controller is now in the programming mode for function selection.
The throttle lever must still be in the full throttle position. Do not release the throttle lever!
• Four different functions can be programmed. These functions are repeated in an endless loop.
The first setting option is provided for selection with one beep. This signal is issued once. The speed controller
switches to the second setting option after approx. three seconds and signals this by a double signal sound, etc., up
to the fourth setting option (four signal sounds). This is followed by a short melody (signal sounds) and then a return
to the first function.
The setting options available can be taken from the table in chapter 11. a).
• When the function that you want to programme is signalled acoustically, move the throttle lever at your transmitter
to the neutral position (motor off). The speed controller now activates the setting of the selected function (1 - 4).
• There are up to eight setting options for each function (see table in chapter 11. a).
These setting options are displayed again at a slightly higher tone now.
Every setting is reported acoustically by an assigned signal sequence (number of sounds); all available settings are
reported by signal in sequence (also an endless loop). The number of sound signals for each change is indicated in
the table in chapter 11. a).
• When the desired setting is signalled by the signal sound (e.g. function 3 "Undervoltage recognition", 3.0 V/cell,
3 brief signals), you need to put the throttle lever into the full throttle position for saving this setting (pull the throttle
lever all the way to the handle).
The throttle lever must be kept in this position until the speed controller confirms successful programming by a
melody (signal sounds).
If you want to make additional settings, continue to keep the throttle lever in the full throttle position. This is followed
by signalling of the following programme item (selection of the functions 1 - 4).
For re-programming, move the throttle lever into the neutral position at the desired function (motor off).
• If you want to cancel/terminate programming, put the throttle lever into the minimum position (to the very front) or
the neutral position.
After approx. two seconds, the signal is given by a short melody with a final long signal.
Now the speed controller can be used with the newly programmed settings. If the throttle lever is still in the full throt-
tle position, programming can also be ended by disconnecting the rechargeable battery from the speed controller.
45