E) Setting The Fin - Reely Mini Mono Bedienungsanleitung

e) Setting the Fin

Your model has a fin installed on the right rear (figure 4). This fin is used to optimise sliding and particularly directional
stability of the model.
The model sliding properties depend on many factors. For example, the weight and installation site of the drive bat-
tery and/or the properties of the water surface (many or few waves) influence the model sliding properties. Therefore,
these operating instructions can to offer specific setting information. You need to perform operation tests to find the
best settings.
Attention!
The fin has sharp edges and may cause damage to objects and/or injury!
36
Figure 4