Mounting The Fin; Installing The Flight Accumulator - Reely Sky Hawk 2.0 Bedienungsanleitung

d) Mounting the Fin
• The fin (1) is slid from above into the unit holder and
aligned.
• The rear edge of the fin dampener must be flush with
the rear edge of the elevator unit damping surface (see
broken line).
Important!
The fin (1) must also be at a 90° angle to the
elevator unit (3) (see sketch).
• Once the fin is exactly aligned, attach it from the left side
with the two 2 x 10 mm screws (2).
e) Installing the flight accumulator
• You have to take off the cabin hood (1) to insert the flight
accumulator. To do so, press the latch (2) forward and
lift the hood off forward on the rear.
• The hood is maintained in place in the front by another
latch that snaps in beneath the fuselage wall. When
putting on the hood, you first have to slide in the catch
beneath the side wall of the fuselage before securing the
hood again with the front latch.
• Prior to connecting the accumulator to the model, you
have to check whether the function switch on the model
(3) is in the rear position (OFF).
• Insert the charged flight battery (4) into the battery com-
partment and connect it with the plug-type connection
(5) of the flight control.
• Once again, the latches of the flight control plug must
engage in the groove of the accumulator plug the same
way as with connection to the charger.
Figure 9
Figure 10
45