9. Using the transmitter
The numbers used in these instructions refer to the gure alongside the text or the illustrations within the
respective section. Cross-references to other gures are indicated with the corresponding gure number.
a) Inserting the batteries
The transmitter is supplied by 4 AA/Mignon batteries. To insert the batteries, proceed as follows:
Loosen the retaining screw (1) on the battery compart-
ment cover on the back of the transmitter. Then push
down on the locking lever (2) and lift off the battery com-
partment cover (3).
Insert the batteries according to the instructions on the
battery compartment (4), observing the correct polarity.
Replace the battery compartment cover with the lower
edge rst and press it rmly at the top until the locking
lever engages.
Then re-tighten the retaining screw.
30
Figure 2