Error Reporting - Datalogic F732 WIZARD Bedienungsanleitung

USE OF EASYGEN™
3.4

ERROR REPORTING

The "Error Variable" reports these possible error conditions:
Error type
No error
<F1> button has been pressed
Division by zero
Table limit reached
Data code not suitable for destination
field
It is the responsibility of the programmer to make sure that the inserted function does
not generate one of these errors by using the comparison function.
The "Error Variable" must be set to the value "00" at program start and reset after
each reporting of an error value.
Variable value
00
1
10
30
31
3
13