Ccommunication Protocol; Communications Frame - Datalogic F732 WIZARD Bedienungsanleitung

C
C COMMUNICATION PROTOCOL
C.1. COMMUNICATIONS FRAME
To receive and/or send data or commands, EasyGen™ uses the following

communications frame:

The figure shows the position of each character constituting the communications
frame of the information to be transmitted or received.
It is possible to configure each character using the "S" type command (see par. C.4
"Configuring the Terminal (Serial Command "S")).
If these parameters are not defined by the user the default configuration is used.
Once a value is attributed to a particular character in the
communications frame, it is important not to attribute it to another
character from the same frame.
In case more than one terminal is connected to the same host
computer, it is essential to configure the Station Address character
so that it assumes different values for each terminal.
NOTE
106
EASYGEN™