Datalogic F732 WIZARD Bedienungsanleitung Seite 196

MENU DESCRIPTION
Row:
Col. (Columns):
Field names:
Path:
If at least one table is selected, it is possible to send it to the Formula terminal by
pressing the <Send> button. When pressing the <Send> button, the following dialog
box appears, from which it is possible to select the specific terminal to which the
selected table data should be sent.
The operation may take several minutes, depending on the length of the tables sent.
At its conclusion, a message appears to indicate the end of the operation.
If, on the other hand, you want to save changes and close the dialog box without
sending them to the terminal, press the <Stop> button.
The <Cancel> button allows to close the dialog box ignoring the changes.
contains the maximum number of records that the
table may hold. This value does not necessarily
coincide with the actual number of records in the
.DAT file.
contains the number of fields defined in the
corresponding table. This value is defined in the
EasyGen™ application and must coincide with the
actual length of the .DAT file lines, otherwise an
error message is generated.
contains the names of all fields (columns) defined
in the table.
contains the path of the .DAT file. If it is empty, by
default SysTools™2001 searches for the .DAT file
in the same directory where the .APP or .POW file
is located. This is an input field. The path is
accepted only if the corresponding .DAT file is the
specified directory.
3
11