Datalogic F732 WIZARD Bedienungsanleitung Seite 236

TROUBLESHOOTING
PROBLEM
The Start command of the
Data Collection window
fails and the message
to
"Unable
communication
Error" appears.
On opening a .PRG file,
the message
to open file
file is not valid"
appears.
On saving a .PRG file, the
message "Unable
save file" appears.
On requesting information
on a device, the message
to
"Unable
with device" or similar
appears.
The serial port is used by
another program.
A serial port has been
open
selected
present.
System error.
SysTools™2001
"Unable read the file .PRG (wrong
or
file) from the disk, or the
program is not valid.
Disk full.
to
Write-protected disk.
Device not connected.
connect
Terminal not correctly lying
in its cradle.
You are connecting with
terminals and you have
also
system.
CAUSE
which is not
cannot
satellites in the
REMEDY
Quit the program that is
using the same serial
port.
Re-set to the right serial
port.
Restart the system.
If available, use a backup
copy of the file.
Free up enough
space for the file you want
to save.
Slide the write protection
tab to the write enabled
position.
Check the
connection.
Correct the
position and try again.
Use setup to
satellites from the system.
5
disk
device
terminal
remove
51