Datalogic F732 WIZARD Bedienungsanleitung Seite 199

3
Set current table...
With this command, you can specify the current EasyGen™ table for a Formula
terminal. This table can then be uploaded from the terminal using the Data Collection
window by pressing the <Start> button.
You can also set the current EasyGen™ table using the function keys on the
terminal.
See par. 4.3 for uploading EasyGen™ table options.
When the <OK> button is pressed and the table isn't in the terminal you have a
"Table not found" message. On the other hand, when no terminal is connected to the
host computer the "Unable to connect with device" error will be displayed.
The Formula terminal must be previously declared to the system
through the Setup function otherwise an error will be signaled.
The loading time obviously depends on the length of the table,
and it may take several minutes to complete.
CAUTION
14
SYSTOOLS™2001