Installing The Brackets; Attach The Brackets To The Camera; Attach The Front And Rear Sun Shields (Provided) To The Camera - Panasonic WV-CW970 Bedienungsanleitung

Installing the brackets

Refer to the installation guides provided with the
brackets.

Attach the brackets to the camera

1. Put the waterproof caps (provided) onto the tops of
the screws.
Attach the front and rear sun
shields (provided) to the camera
1. Hold the front and rear sun shields by the
indentations on the rims and release the hooks from
both sides to separate them.
A wire is attached to one side to prevent them from
being lost.
Unhook
2. Hold the front and rear sun shields near the Upper
Base in position to be mounted.
Indented parts
Wire
3. Before clamping the sun shield, close the front and
rear sun shields (first latch the hook on the wire
side, and then do the other side).
* Take care that the camera safety wire does not go
on the inside.
Camera
Safety wire
4. Align the arrow ( ▽ ) on the rear sun shield with the
"START" arrow (△) on the sun shield and then turn
them to the "LOCK" arrow (△) until they click.
5. Use the screws on the front/rear sun shields to
attach them to the camera.
Recommended tightening torque: 5.0 N/m {51 kgf
cm}
Note: To remove the front/rear sunshields from the
camera, do the above procedure in reverse.
Caution: The camera safety wire is designed to allow
the camera to hang from it. Do not apply force greater
than the weight of the camera to the wire.
-17-
Sun shield
Align with this arrow