Installing The Brackets; Attach The Brackets To The Camera; Attach The Front And Rear Sun Shields (Provided) To The Camera - Panasonic WV-CW960E Bedienungsanleitung

WV-CW960_US 05.11.18 11:08 ページ18

■ Installing the brackets

Refer to the installation guides provided with the
brackets (WV-Q122 etc), which are sold separately, for
information on how to install them.

■ Attach the brackets to the camera

Refer also to the installation guides provided with the
brackets (WV-Q122 etc), which are sold separately, for
information on how to install them.
1. Put the waterproof caps onto the tops of the
screws.
■ Attach the front and rear sun
shields (provided) to the camera
1. Hold the front and rear sun shields by the
indentations on the rims and release the hooks from
both sides to separate them.
A wire is attached to one side to prevent them from
being lost.
2. Hold the front and rear sun shields near the Upper
Base in position to be mounted.
Downloaded from www.Manualslib.com
x3 Screws
Upper Base
Enclosure
Indented parts
Wire
Unhook
manuals search engine
3. Before clamping the sun shield, close the front and
rear sun shields (first latch the hook on the wire
side, and then do the other side).
* Take care that the camera safety wire does not go
on the inside.
Camera Safety wire
4. Align the arrow ( ▽ ) on the rear sun shield with the
"START" arrow (△) on the sun shield and then turn
them to the "LOCK" arrow (△) until they click.
Align with this arrow
5. Use the screws on the front/rear sun shields to
attach them to the camera.
Note: To remove the front/rear sunshields from the
camera, do the above procedure in reverse.
Caution: The safety wire is designed to allow the
camera to hang from it. Do not apply force greater than
the weight of the camera to the wire.
-18-
Sun shield