Connecting the Telephone to a PC
Requirements
–
A PC that meets the system requirements (see chapter Important Informa-
tion > Minimum Requirements PC)
–
A telephone, put into operation
–
Network cable
Switch on the PC.
1.
Insert a plug (RJ-45) of the network cable into the socket labelled with
2.
on the bottom of the telephone.
Important: If you connect a PC to the
tions in operation. This socket must be used to connect to the network and
the power supply (PoE).
Take note of the socket labels.
Insert the other plug (RJ-45) of the network cable into the network connec-
3.
tion port of your PC.
Configuring the Telephone via the Configuration Manager
Requirements
–
Existing network connection between the PC and the telephone
–
Knowledge of the IP address of the telephone (can be queried under Menu
> System Settings > Advanced Settings > Network > LAN Port > IP)
Start a browser.
1.
Enter the IP address of the telephone in the address bar of the browser
2.
(for example, http://192.168.178.4).
Note: If operated as standard VoIP telephone: when you start the configu-
ration manager for the first time, a dialogue in which you set the username
and the user password appears in a first step. Enter these parameters as
requested.
Under Username and Password, enter the following parameters.
3.
i
COMfortel 1200 IP - Setup V03 09/2016
If operated as a system telephone: The admin username and the
admin password of the PBX.
Commissioning
socket, this will result in disrup-
47