Output Request Data Setting - Sony LZ51-C Bedienungsanleitung

3-4-5. Output Request Data Setting

This sets the RS-232C data when the "R" command (data output request command) is input.
(Continued from 3-4-1 (2).) (P.68)
1. Select "r" and press .
ENTER
Selects the RS-232C output data when "R" command is
input.
The initial value is the addition/subtraction axis (Add) of the
current value (Cr).
The selected item flashes.
"Cr" : Current value
"MX" : Maximum value
"MN" : Minimum value
"PP" : Peak-to-peak value
2. Select the desired item with the cursor movement keys
.
• To enter the settings
3. Select the data you wish to output and press
Enters the output data when "R" command is input.
(In this case, the maximum value (MX) is output.)
The setting contents light steadily for approximately
2 seconds for confirmation.
However, when the output request data is set to the current value (Cr), the 1st axis, 2nd axis and addition/subtraction axis
Main display
Sub-display
.
ENTER
Main display
Sub-display
Main display
Sub-display
(Lights)
↓
(After approx. 2 sec.)
83