Initial Settings (Be Sure To Perform These Preparatory Operations Before Use.) - Sony LZ51-C Bedienungsanleitung

3-4. Initial Settings (Be sure to perform these preparatory operations before use.)

This section describes the method for inputting the various setting items.
•
The initial settings can be performed by one of the following two methods.
AUTO (Collective automatic settings): Code input according to a code table (See P.71.)
MANUAL (Individual item settings): Setting using the display (See the configuration below.)
The initial settings should be performed separately for the "main unit" and the "expansion unit".
RS-232C initial setting menu configuration
Initial settings
MAIN
(Main settings)
rSC
(RS-232C
settings)
(P.67 3-4-1.)
Expansion
unit* 1
Expansion
1
unit*
*1 Displayed when other optional expansion units are installed.
*2 "End" for Ver. 01.0E and earlier versions instead of "VEr".
The boxed numbers for the items above refer to the numbers of the descriptions ("Initial value" and "Setting hints") starting from the next page.
See the LY51 instruction manual.
AUTO
(Collective automatic
settings)
HArd 1 1 1 1 1
MANUAL
(Transfer speed and
(Individual item
other settings)
settings)
(P.72 3-4-3.)
AdrS 2 2 2 2 2
(Unit No. setting)
(P.78 3-4-4.)
r 3 3 3 3 3
(Output request
selection)
(P.83 3-4-5.)
End
VEr* 2
(Return to RS-232C
(Version display)
settings)
To collective setting by code input (P.69 3-4-2.)
brT
(Transfer speed setting)
PTy
(Parity setting)
dAT
(Data length setting)
End
(Return to MANUAL)
MX
(Maximum unit No. setting)
No.
(Own unit No. setting)
End
(Return to MANUAL)
STP
(Stop bit setting)
(Reserved)
(Reserved)
End
(Return to MANUAL)
65