Link Connection - Sony LZ51-C Bedienungsanleitung

5-6. Link Connection

When using link connection, be sure to attach the unit No. (1 to 4) in front of the main command. If the unit No. is not attached,
the command is executed for the 1st unit. ( unit No. command )
When using link connection, do not continuously send the reset command "C" for switching to the count display from the initial
setting display; insert a wait for each command. Continuous "C" commands may not be accepted.
When using link connection, turn on the power for all units at the same time.
If this is not possible, turn on the power of each unit in order from the smallest unit No., leaving less than 3 seconds between
each unit.
Note
When using link connection, do not perform PRINT key operations for multiple units at the same time. When performing
operations for one unit, wait for the operations to finish and then operate the other unit.
100