Sony LZ51-C Bedienungsanleitung Seite 95

To clear all initial settings and return to the default settings, input the "I" command.
When the LZ51-K/LZ51-R is connected, the comparator setting values are all zero.
• Factory-set values
1 Power-on display mode: Initial setting mode
2 Input scale addition/subtraction setting: 1st and 2nd axis addition
3 Main and sub-display data selection:
Main → Current value, Sub 1 → Minimum value, Sub 2 → Maximum value
4 Input scale resolution:
Magnescale → 0.0005 mm, Digiruler → 0.01 mm, GA → 0.005 mm, Other → 0.0005 mm
5 Display resolution:
Magnescale → 0.0005 mm, Digiruler → 0.01 mm, GA → 0.005 mm, Other → 0.0005 mm
6 Linear compensation: None
7 Universal input signal selection: External restart
8 Universal output signal selection: Display mode, alarm
9 Key lock function signal enable/disable: Disabled
0 Current value data storage enable/disable: Disabled
!¡ A/B phase (or up/down signal) output setting (valid only when using the LZ51-H):
1st axis, A/B phase output
Other LZ unit initial setting values are the default settings.
However, the transfer speed and other settings for the LZ51-C are not changed.
Note
After sending the "I" command, go to the count display and turn off the power. The "I" command initializes the
entire memory, so "d.Error" may appear when the power is turned on next.
After the "I" command is sent, the comparator target value may be set to the 1st axis current value.
93