Appendix-Fax/Data Menu; Incoming Calls - Sony QN-022PCM Bedienungsanleitung

APPENDIX- Fax/Data Menu
CMD-Z1 has Fax/Data menu which consists of 3
configurations;
1) Speech Only
2) Speech Then Fax
3) Fax/Data Only

Incoming calls

In GSM system, an incoming call usually specifies a type of
service, so that the GSM phone which receives the incoming
call can recognise what kind of call (speech, fax or data) is
GB
requested by the call-originating side. If the service is
supported by the GSM phone, the GSM phone rings you to
answer the call.
In such a case, your CMD-Z1 will ignore the setting of Fax/
Data menu.
However, the GSM phone may receive an incoming call which
does not specify the type of service. In such a case, a service
will be selected to establish the call by the GSM phone instead
of the call-originating side.
Your CMD-Z1 can select a service according to this Fax/Data
setting for the call as follows;
•Speech Only
Speech is selected for the incoming call.
After the call is established, speech communication will be
available.
•Speech Then Fax
"Speech Then Fax" is selected for the incoming call.
After the call is established, speech communication will be
available at first.
You can send a fax message when the PCMCIA card is
connected to your CMD-Z1 and your fax software on the PC
is activated in correct way.
•Fax/Data Only
If the PCMCIA card is connected to your CMD-Z1 and if your
terminal or fax software on the PC is activated in correct way,
the PC software will either select data or fax service.
Otherwise, speech will be selected, same as "Speech Only".
GB
11
QN-022PCM 3-860-382-11