3. Link connection
•
When using link connection, the optional LZ52 link cable is
necessary. Remove the caps from the connectors marked
"LINK" on the LZ51-C unit, and connect the display units
using the LZ52 cable. Both "LINK" connectors operate the
same.
•
When using link connection, the "Unit No. setting" (P.78) in
the initial settings must be performed. Be sure to set the
unit Nos. before turning on the power.
•
When using link connection, turn on the power for all units
at the same time. If this is not possible, turn on the power
of each unit in order from the smallest unit No., leaving
less than 3 seconds between each unit.
Note
Failure to set the unit Nos. may damage the display unit.
64
3-3. Checking the Initial Settings
The data output format and other items for the expansion
unit are set by the initial settings.
Be sure to check the setting of each item and set the
necessary contents before operation.