IFM Electronic Ecomat 100 Handbuch Seite 42

CR2102
INCLINATION SENSOR
Name Data type
Longitudinal axis (X)
SlopeLong INT
Offset
SlopeLong INT
Differential
Lateral axis (Y)
SlopeLateral BOOL
Sign
SlopeLateral BOOL
ScaleEnable
SlopeLateral INT
Preset
SlopeLateral INT
Offset
SlopeLateral INT
Differential
42
PAGE
Description
Offset value calculated from the entered values.
Offset value = SlopeLongPreset t
(t : Instant when the "SlopeLongPreset" was set)
acc
To read the value, "CFG_READ" must be set to TRUE until the
output "CFG_RESULT has again the value "1". SlopeLongOffset is
write-protected.
(See parameter setting and alignment of the sensor, page 37)
Shifts the inclination of the longitudinal axis by the specified value.
A set "SlopeLongPreset" does not affect shifting.
keinen Einfuß.
To adopt the value the input "CFG_WRITE" must be set to TRUE
until the output "CFG_RESULT" has again the value "1".
(See parameter setting and alignment of the sensor, page 37)
Representation of the sign of the inclination of the lateral axis (Y)
FALSE (0) = as indicated by the manufacturer on the housing label
TRUE (1) = inverted sign
If the variable TRUE is set, the inclination of the lateral axis
is scaled depending on the entered values
"SlopeLateralPreset" and "SlopeLateralDifferential".
FALSE (0) = scaling deactivated
TRUE (1) = scaling activated
Corrects the measured sensor value.
The inclination of the lateral axis is set to the entered value.
The offset can be retrieved via "SlopeLateralOffset".
To adopt the value the input "CFG_WRITE" must be set to TRUE
until the output "CFG_RESULT" has again the value "1".
(See parameter setting and alignment of the sensor, page 37)
Offset value calculated from the entered values.
Offset value = SlopeLateralPreset t
(t : Instant when the "SlopeLateralPreset" was set)
acc
To read the value, "CFG_READ" must be set to TRUE until the
output "CFG_RESULT has again the value "1".
SlopeLongOffset is write-protected.
See parameter setting and alignment of the sensor, page 37)
Shifts the inclination of the lateral axis by the specified value.
A set "...SlopeLateralPreset" does not affect shifting.
To adopt the value the input "CFG_WRITE" must be set to TRUE
until the output "CFG_RESULT" has again the value "1".
(See parameter setting and alignment of the sensor, page 47)
– measured sensor value t
acc
– measured sensor value t
acc
acc
acc