Fault Code; Possible Cause; Corrective Action; Possible Faults - ATIKA ELB 52 Originalbetriebsanleitung

Before each fault elimination:
 Switch off device.
 Wait until the cutting device does not longer move.
 Allow the machine to cool down.
 Close vent valve.
 Remove the spark plug connector.
 Wear gloves.

After each fault clearance, put into operation and recheck all security installations.

Fault code

Motor does not start
Engine starts and is
stalled immediately
Chain saw works with
interruptions
Smoke
Machine does not work
with full performance
Drill rotates at idling
Drill rotates but has no
power
Drill jumps
Drill cuts only slowly

Possible cause

 Incorrect starting sequence
 Air filter contaminated.
 Fuel filter fouled
 No fuel supply
 Fault in the fuel line
 Cranking mechanism defective
 Engine flooded.
 Spark plug connector not placed on.
 No ignition spark.
 Engine defective.
 Carburettor defective
 Incorrect idle adjustment
 Carburretor incorrectly adjusted
 Spark plug fouled
 Incorrect fuel mixture
 Carburretor incorrectly adjusted
 Machine overloaded.
 Air filter contaminated
 Carburretor incorrectly adjusted
 Silencer blocked
 Idle speed too high
Clutch spring broken

 Choke put to OFF
Carburetor defective

 Gear broken
Worn clutch shoes

Drill damaged

 Blunt drill
P o s s i b l e f a u l t s
P o s s i b l e f a u l t s

Corrective action

 Observe the correct starting sequence
 Clean or replace the air filter
 Clean or replace the fuel filter
 Fill the fuel tank.
 Check the fuel line for kinks or damages
 Contact the customer service
 Screw off, clean and dry the spark plug. Then pull the
cranking rope several times and reinstall the spark
plug
 Place on the spark plug connector.
 a) Clean or replace the spark plug.
b) Check the ignition cable.
c) Fault cannot be eliminated?
Contact the customer service
 Contact the customer service
 Contact the customer service
 Contact the customer service
 Contact the customer service
 Clean or replace the spark plug Check the spark plug
connector
 Use two-stroke oil, ratio of mixture 40:1
 Contact the customer service
 Soil too tough
 Clean or replace the air filter
 Contact the customer service
 Clean the outlet of the silencer
 Adjust a lower idle speed
Replace the spring

 Put choke to ON once the engine runs
Contact the customer service

Contact the customer service

Replace the clutch shoes and the spring

Replace by a new drill

 Replace the drill or have it sharpened
23