Advanced User Guidebook - PeakTech 1360 Bedienungsanleitung

4. Advanced User Guidebook

Up till now, you have already been familiar with the basic operations of the function areas,
buttons and knobs in the front panel of the oscilloscope. Based the introduction of the
previous Chapter, the user should have an initial knowledge of the determination of the
change of the oscilloscope setting through observing the status bar. If you have not been
familiar with the above-mentioned operations and methods yet, we advise you to read the
section of Chapter 4 "Junior User Guidebook".
This chapter will deal with the following topics mainly:

How to Set the Vertical System

How to Set the Horizontal System

How to Set the Trigger System

How to Implement the Sampling Setup

How to Set the Display System

How to Save and Recall Waveform

How to Cut and Recall a waveform

How to Record/Playback Waveforms

How to Implement the Auxiliary System Function Setting

How to Implement the Automatic Measurement

How to Implement the Cursor Measurement

How to Use Autoscale function

How to Use Executive Buttons
It is recommended that you read this chapter carefully to get acquainted the various
measurement functions and other operation methods of the oscilloscope.
4.Advanced User Guidebook
25