PeakTech 1360 Bedienungsanleitung Seite 165

Type
When the type is Wave, the menu shows as following:
Source
Object
Object & Show Show
Save
Storage
When the type is Configure, the menu shows as following:
Configure
Save
Load
When the type is Image, the menu shows as following:
4.Advanced User Guidebook
Wave Choose the saving type.
Configure About the Record type, see "How to
Image Record/Playback Waveforms" on P57.
Record
CH1
CH2 Choose the waveform to be saved.
Math
Choose the address which the waveform is
0 - 99
saved to or recall from.
Recall or close the waveform stored in the
current object address. When the show is
ON, if the current object address has been
ON used, the stored waveform will be shown,
OFF the
information will be displayed at the top left
of the screen; if the address is empty, it
will prompt "None is saved".
Close all the waveforms stored in the
Close All
object address.
Save the waveform of the source to the
selected address. Whatever the Type of
save menu is set, you can save the
waveform by just pressing the Copy panel
button in any user interface. Storage format
is BIN.
Save to internal storage or USB storage.
When External is selected, save the
waveform according to the current record
Internal
length (see "
External
the file name is editable. The waveform
file could be open by waveform
analysis software (on the supplied CD).
Setting1
.....
The setting address
Setting8
Save the current oscilloscope configure to
the internal storage
Recall the configure from the selected
address
51
address number
Record Length menu
and relevant
" on P48);