PeakTech 1360 Bedienungsanleitung Seite 153

CH1
Source
CH2
Up Level
Threshold
Low Level
Polarity
Condition
Auto
Normal
Single
Mode
Holdoff
Holdoff
Reset
6.Windows Trigger
Provide a high trigger level and low trigger level, the oscilloscope triggers when the
input signal passes through the high trigger level or the low trigger level.
In Windows Trigger mode, the trigger setting information is displayed on bottom right
of the screen, for example,
4.Advanced User Guidebook
Select CH1 as the trigger source.
Select CH2 as the trigger source.
Adjust the M knob or click
threshold.
Adjust the M knob or click
threshold.
Positive Polarity, the oscilloscope triggers on the
positive runt pulse.
Positive Polarity, the oscilloscope triggers on the
negative runt pulse.
Adjust the M knob or click
press
move cursor to choose which digit to be set.
Trigger when runt pulse is greater than the set pulse
Trigger when runt pulse equals to the set pulse width.
Trigger when runt pulse is lower than the set pulse
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform then stop
100 ns - 10 s, adjust M knob or click
interval before another trigger occur， press
panel button or click
which digit to be set.
Set Holdoff time as 100 ns
39
to set the up level
to set the low level
to set pulse width,
panel button or click
width.
width.
to move cursor to choose
，indicates that trigger type is
to
to set time