PeakTech 1360 Bedienungsanleitung Seite 172

Cur frame
Play mode
Operate
Storage: Save the current wave according to the start frame and end frame set.
Storage menu shows as follows:
Menu Setting
Start frame
Storage
Mode
Frame Set
End frame
Save
Load
To use wave record function, do as follows:
(1) Push Save button.
(2) Select Type in the bottom menu, in the left menu, turn the M knob to select
Record.
(3) Select Mode in the bottom menu, select OFF in the right menu.
(4) In the bottom menu, select Storage as Internal.
(5) Select Mode in the bottom menu, select Record in the right menu.
(6) Select FrameSet in the bottom menu, set End frame and Interval in the right
menu.
(7) In the bottom menu, set Refresh.
(8) In the bottom menu, select Operate as Play.
(9) Select Mode in the bottom menu, select Playback in the right menu. Set
FrameSet and Playmode, select Operate as Play.
(10) To save the wave recorded, select Mode in the bottom menu, select Storage in
the right menu. Select FrameSet in the bottom menu to set the range of frames to
store, select Save in the bottom menu.
(11) To load the waveform from the internal memory, select Load in the bottom menu,
then enter the Playback of the Mode to analyze the wave.
Note: When playbacking the waveform, the sampling, trigger, or display function is
not available.
When storage medium is External, Wave Record contains two modes: OFF,
Record.
4.Advanced User Guidebook
to playback (1 - 1000)
Turn the M knob to select the number of current
frame to playback (1 - 1000)
Interval Turn the M knob to select the interval between
played back frames (1ms - 1000s)
Loop Play back the wave continuously
Once Play back the wave just one time
Play Begin to record
Stop Stop recording
Turn the M knob to select the number of start frame
to store (1 - 1000)
Turn the M knob to select the number of end frame to
store (1 - 1000)
Save the waveform record file to the internal memory
Load the waveform record file from the memory
Instruction
58