PeakTech 1360 Bedienungsanleitung Seite 166

Save
Save and Recall the Waveform
The oscilloscope can store 100 waveforms, which can be displayed with the current
waveform at the same time. The stored waveform called out can not be adjusted.
In order to save the waveform of the CH1 into the address 1, the operation steps
should be followed:
1. Push the Save button.
2. Saving: Select Type in the bottom menu, in the left menu, turn the M knob to
select Wave.
3. Select Source in the bottom menu, select CH1 in the right menu for Source.
4. Select Object & Show in the bottom menu, turn the M knob to select 1 as object
address in the left menu.
5. Select Storage in the bottom menu, select Internal in the right menu.
6. Select Save in the bottom menu to save the waveform.
7. Recalling: Select Object & Show in the bottom menu, select 1 in the left menu.
In the right menu, select Show as ON, the waveform stored in the address will be
shown, the address number and relevant information will be displayed at the top
left of the screen.
Tip:
Whatever the Type of save menu is set, you can save the waveform by just pressing
the Copy panel button in any user interface. If the Storage of the save menu is set as
"External", you should install the USB disk. Please refer to the contents below to
install the USB disk and name the file to be saved.
Save the current screen image:
The screen image can only be stored in USB disk, so you should connect a USB disk
with the instrument.
1. Install the USB disk: Insert the USB disk into the "7. USB Host port" of
"Figure 3-1 Front panel". If an icon
USB disk is installed successfully. If the USB disk cannot be recognized, format
the USB disk according to the methods in "USB disk Requirements" on P53.
2. After the USB disk is installed, push the Save panel button, the save menu is
displayed at the bottom of the screen.
4.Advanced User Guidebook
Save the current display screen. The file
can be only stored in a USB storage, so a
USB storage must be connected first. The
file name is editable. The file is stored in
BMP format.
appears on the top right of the screen, the
52