PeakTech 1360 Bedienungsanleitung Seite 177

means stop once the condition satisfies your setting.
5. Begin to test: Select Operate in the bottom menu, select Operate in the right
menu as Start, the test will begin.
6. Save rule: Select SaveRule in the bottom menu. Select the save location in the
left menu, and then select Save in the right menu to save the rules, which could be
called up at once when need. Select Load to call up the rule saved.
Note:
1. When Pass/Fail is ON, if XY or FFT is ready to run, then Pass/Fail will be closed;
under the mode of XY or FFT, Pass/Fail is unable.
2. Under the mode of Factory, Auto Scale and Auto Set, Pass/Fail will be closed.
3. When no save setting left in the rule save, tip will be given to show "NO RULE
SAVED".
4. Under the status of stop, data comparing will stop, and when it goes on running,
the number of Pass/Fail will increase from the former number, not from zero.
5. When the waveform playback mode is on, Pass/Fail is used to test the
played-back waveform specially.
● Output
Push the Utility button, select Function in the bottom menu, select Output in the left
menu.
Output menu item in the bottom menu sets the output type of 12.Trig Out(P/F) port
in Figure 3-3 Rear Panel on P6. In the bottom menu, select Output. The description
of Output menu is shown as the follows:
Function
Setting
Menu
Trig level
Pass/fail
Type
AG
Output
Video menu item in the bottom menu sets the output port of video. In the bottom
menu, select Video. The description of Video menu is shown as the follows:
Function
Setting
Menu
OFF
VGA
Video
AV
Device and Print Setup menu items set the print output, refer to "How to Print the
Screen Image" on P74.
4.Advanced User Guidebook
Description
Output trig signal synchronously
Output High Level when Pass , and Low Level when Fail
Output (single channel) or CH1 Output (dual-channel) of
waveform generator (optional)
Description
Turn off video output
Connect the VGA or AV port to an external monitor or
projector. Select the port in this menu, the oscilloscope
display can be shown on an external monitor or projector.
63