Maintenance And Cleaning - Kalor Insert Hydro 17 Bedienungsanleitung

Maintenance and cleaning

All cleaning of all parts must be carried out with the Hydro Insert completely cold
and unplugged to avoid burns and thermal shock. The Hydro Insert does not need
much maintenance if used with certified quality pellet. The need for maintenance
varies depending on the conditions of use (switching on and off repeatedly) and
depending on the performance required.
of the Hydro Insert to check its condition.
Parts
Brazier
Cleaning the ash collection
compartment with suction device
Cleaning ash tray
Cleaning the interior heat exchanger /
smoke fan compartment
Cleaning complete exchanger
Clean "T" to exhaust
Flue
Door gasket ash
Internal parts
Flue pipe
Circulation pump
Hydraulic components
Electromechanical components
◊ by the user / • by the authorised qualified technical assistance
BY THE USER
Daily control
The Hydro Insert requires a simple and thorough
cleaning in order to ensure a more efficient
performance and
cleaning the inside of the Hydro Insert, to prevent
the escape of ashes, you can start the fan flue
exhaust. Clean the grate from the ash and any
incrustation which could obstruct the passage of
air. In the case of depletion of pellets in the tank
may accumulate unburned pellets in the burn pot.
Always empty the residuals from the grate before
each start. Remember that only a brazier located
and clean properly can ensure ignition and optimal
operation of your Hydro Insert. When positioning
the crucible, carefully check that the ends of the
pads completely adhere to their home and that
the hole with pipe dedicated to the passage of the
resistance. There should be no residual combustion
in the contact zone between the edges of the
crucible and the support surface on the door
crucible.
38
Every 2-3
Everyday
◊
smooth operation.
It is recommended periodic monitoring
Every Every 15
days week days
◊
◊
While
Every 30 Every 60- Every 1
days 90 days
•
•
•
year
•
•
•
•
•
•
•