Kalor Insert Hydro 17 Bedienungsanleitung Seite 133

Controllo ogni 2-3 giorni
Cleaning the ash collection compartment
Clean and empty the ash tray being careful with
hot ash. The ash must be completely cold for a
vacuum cleaner to be used to remove it. Only if the
ash is completely cold, you can also use a canister
vacuum cleaner suitable for picking up particles of
a certain size.
Cleaning ash and combustion chamber including
the spark plug lead.
Flame-shell cleaning
Cleaning of stainless steel and satin-finish
surfaces
Normally these surfaces do not need to be treated,
but if they do, avoid cleaning them with abrasive
materials. For surfaces in stainless and satin
brushed steel we recommend cleaning with a
paper towel or a clean dry cloth moistened with a
detergent based on non-ionic surfactants (<5%) A
spray glass cleaner may be used.
Avoid contact with skin cleanser
and eyes. In case this happens,
sprinkle with plenty of water
and contact the nearest medial center.
Cleaning of painted pats
Do not clean the painted parts with wet rags when
the unit is in operation or hot to prevent thermal
shock to the paint which may cause it to detach.
Do not use abrasive or aggressive products or
materials. Clean with damp cotton or paper towels.
The silicon paints used by manufacturer possess
technical characteristics that make them resistent
to very high temperatures. There is however a
physical limit (380° C - 400° C) beyond which the
paint begins to fade or (over 450°) to vitrify; it may
then flake and detach from the steel surface. If this
happens, it means that temperatures have been
reached that are far above those at which the unit
should operate properly.
Do not use abrasive materials or
harsh. Clean with damp cotton or
paper towels.
Lower ash drawer cleaning
Si raccomanda la pulizia del cassetto cenere dai
residui caduti durante il funzionamento. Remove
the grid, take out the tray, empty and clean the
corners with a suction device.
Shutting the Hydro insert down
In the period when the Thermostove is out of use
it must be disconnected from the electricity mains.
For greater safety, especially if there are children
around, we recommend removing the power
cable from the rear of the Hydro insert.
39