Kalor Insert Hydro 17 Bedienungsanleitung Seite 97

• Use only wood pellets;
• Keep / store the pellets in a cool dry place;
•Never pour pellets directly on the hearth;
• The Hydro Insert must only be fed with quality 6 mm diameter pellets, A1 certified
according to the UNI EN ISO 17225-2 regulations;
• Before making the electrical connection of the Hydro Insert the discharge tubes must be
connected with the flue;
• The protective grill placed inside the pellet container must never be removed;
• The environment where the Hydro Insert is installed must have a sufficient exchange of
air;
• It is forbidden to operate the Hydro Insert with the door open or the glass broken;
• Do not use the Hydro Insert as an incinerator; the Hydro Insert should be used only for
the intended purpose;
• Any other use is considered improper and therefore dangerous. Do not put in the hopper
other than wood pellets;
• When the Hydro Insert is operating, the surfaces, glass, handle and tubes become very
hot: during operation do not touch these parts without adequate protection;
• Keep the fuel and other inflammable materials off the Hydro Insert.
Charge pellet
Fuel is loaded from the upper part of the Hydro Insert by
opening a door. Pour the pellets in the hopper.
This is easier if performed in two steps:
• Pour half of the contents of the bag into the hopper
and wait for the fuel to settle on the bottom.
• Then pour in the second half;
• Keep the cover closed , after loading the pellets , the
lid of the fuel tank;
The Hydro Insert is a product by heating, presents
the external surfaces particularly hot. For this reason,
we recommend extreme caution when operating in
particular:
• Do not touch the Hydro Insert body and the various
components, do not approach the door , it could cause
burns;
• Do not touch the exhaust fumes;
• Do not perform any type of cleaning;
• Do not dump the ashes;
• Do not open the ash tray;
• Be careful that children do not come near;
Never remove the protection grille
in the hopper. When filling, do not
let the sack of pellets touch any
hot surfaces.
3