Operating The Model; Inserting The Drive Battery; B) Connecting The Drive Battery - Reely Futterboot ARR Bedienungsanleitung



9. Operating the Model

a) Inserting the Drive Battery
Open the body cover.
The drive battery (1) must be attached to the bottom
of the body with hook-and-loop tape so that it will be
kept secure in its position even in rough operation
The battery should be mounted as close to the motor
(2) as possible for best running properties.
Figure 5, item 3 shows the assembly site for the
receiver battery that is attached to the holder with
rubber bands. The on/off switch (4) of the receiver
battery is attached to the side of the holder with
double-sided adhesive tape.
Observe tight fit of the driving battery. We recommend that the battery be attached to the wood board with an
additional strip of hook-and-loop tape taped into the boat body, rather than only those present. The material
required for this is not part of the delivery and must be procured separately.

b) Connecting the Drive Battery

Switch on the transmitter and the receiver and set the trimming of all control functions to the neutral position. Observe
the information and instructions in the operating instructions of the remote control system.
Place the boat on a suitable surface (e.g. on the included boat rack) so that the ship's propeller can move freely.
Connect the plug connections on the driving battery to the counter-piece of the speed controller.
The speed controller starts to initialise at once. When everything is just right, this is indicated with a brief signal sound
(melody). The LED integrated in the speed controller goes out. The speed controller is now ready for operation. If the
LED flashes and you hear a signal sound at the same time, the trimming of the speed control is adjusted.
If successful initialisation is not reported acoustically, the speed controller is not ready for operation either. In
this case, carefully adjust the speed control trimming at the transmitter (see operating instructions of the
remote control system) until the sound signals are issued. You may also need to remove the drive battery for
this. It must be reconnected after approx. 10 seconds.
Figure 5
31