Leds On Battery; Led On Charger; Assembling The Lawn Mower - Stihl Rma 235.1 Gebrauchsanleitung

7 Assembling the Lawn Mower

► Plug the mains plug (6) into an easily accessi‐
ble socket (7).
The charger (3) will run a self-test. The
LED (4) will glow green for about 1 second
and red for about 1 second.
► Routing the connecting cord (5).
► Insert the battery (2) in the guides in the
charger (3) and press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow
green and the battery (2) is being charged.
► When the LED (4) and the LEDs (1) on the
battery no longer light up: The battery (2) is
fully charged and can be removed from the
charger (3).
► If the charger (3) is no longer required: Dis‐
connect the mains plug (6) from the wall out‐
let (7).
6.3 Displaying the state of charge
1
► Depress the pushbutton (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
18.
There is a malfunction in the mower or battery.
6.5

LED on Charger

The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
0478-131-9981-A
7
7.1
► Switch the lawn mower off and remove the
► Place the lawn mower on a level surface.
80-100%
60-80%
40-60%
20-40%
0-20%
► Hold lower handlebars (1) against the lawn
► Push screws (3) together with washers (2)
► The upper handlebar can be installed at 2
Assembling the Lawn
Mower
Attaching the Handlebar
battery.
mower so the bores align.
through the bores in lower handlebar (1) and
lawn mower (4) from the outside inwards,
screw in and tighten to 3 Nm.
Both lower handlebars (1) are firmly attached
to lawn mower (4).
heights (a, b).
English
39