Leds On Battery; Activating And Deactivating Bluetooth® Radio Interface; Assembling The Lawn Mower - Stihl RMA 443.2 Gebrauchsanleitung

7 Activating and Deactivating Bluetooth® Radio Interface
6.2 Displaying the Charge State
► Press button (1).
The LEDs illuminate green for approx. 5 sec‐
onds to indicate the charge state.
► If the right LED flashes green: charge the bat‐
tery.
6.3

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
20.1.
There is a malfunction in the mower or battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
0478-131-9960-C
Radio
®
®
radio interface:
symbol
®
®
radio interface:
symbol
8 Assembling the Lawn
Mower
8.1 Attaching the Handlebar
► Switch the lawn mower off, pull out the activa‐
tion key and remove the battery.
► Place the lawn mower on a level surface.
► Fit sleeves (1) onto lower handlebars (2).
► Push screw (3) through the bore in cable
guide (4).
► Fit upper handlebar (5) onto lower handle‐
bars (2).
► Attach cable guide (4) to cable (6).
► Push screws (3) through bores (7) from the
inside to the outside.
► Fit quick-clamping device (8) onto screws (3)
and screw in.
► Close quick-clamping devices (8) in the direc‐
tion of upper handlebar (5).
Upper handlebar (5) is firmly attached to lower
handlebars (2) and quick-clamping devices (8)
lie flat against upper handlebar (5).
► Press cable (6) into the holder on handle (9).
► Press cable clip (10) onto upper handlebar (5).
► Place cable (6) into cable clip (10).
► Close tab (11) and allow it to engage.
English
33