Stihl Ak Battery; Stihl Al 101 Charger; Extension Cords; Temperature Limits - Stihl Rma 235.1 Gebrauchsanleitung

19 Specifications
19.3

STIHL AK Battery

– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: See rating label
19.4

STIHL AL 101 Charger

– Rated voltage: See rating plate
– Frequency: see rating plate
– Rated power: see rating plate
– Charging current: See rating plate
For charging times, see www.stihl.com/charging-
times.
19.5

Extension Cords

If an extension cord is used, the cross sectional
area of its conductors must meet the following
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
– Cord length up to 20 m: AWG 15 / 1.5 mm²
– Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
If rated voltage on the rating label is 100V to
127V:
– Cord length up to 10 m: AWG 14 / 2.0 mm²
– Cord length 10 m up to 30 m: AWG 12 /
3.5 mm²
19.6

Temperature Limits

WARNING
■ The battery is not protected against all ambi‐
ent conditions. If exposed to certain ambient
conditions, the battery may catch fire or
explode. This may result in serious injury to
people and damage to property.
► Do not charge or use the battery below
-20 °C or above +50 °C.
► Do not store the battery below -20 °C or
above +70 °C.
► Do not use the lawn mower below 0 °C or
above + 50 °C.
► Do not store the lawn mower below - 20 °C
or above + 70 °C.
0478-131-9981-A
19.7 Recommended Temperature
Ranges
For optimum performance of the lawn mower,
the battery and the charger, observe the follow‐
ing temperature ranges:
– Lawn mower:
– Usage: 0 °C to +40 °C
– Storage: -20 °C to +50 °C
– Battery and charger:
– Charging: +5 °C to +40 °C
– Use: -10 °C to +40 °C
– Storage: -20 °C to +50 °C
If the battery is charged, used or stored outside
the recommended temperature ranges, perform‐
ance may be reduced.
If the battery is wet or damp, allow it to dry for at
least 48 hours at above +15 °C and below
+50 °C and at less than 70% humidity. Higher
humidity may increase the drying time.
19.8 Sound and vibration values
– Sound pressure level L
ance with EN IEC 62841-4-3: 76 dB(A)
– Uncertainty K : 3 dB(A)
pA
– Guaranteed sound power level L
ured in accordance with 2000/14/EC: 90 dB(A)
Specified vibration characteristic in accordance
with EN 12096:
– Vibration value a measured in accordance
h
with EN IEC 62841‑4‑3, handlebar: 1.80 m/s²
– Uncertainty K : 0.9 m/s²
h
The sound and vibration values indicated were
measured according to a standardized test
method and can be used as a basis for compar‐
ing electric power tools. The actual sound and
vibration levels may vary from the values indica‐
ted, depending on the type of application and the
accessories used. The sound and vibration lev‐
els indicated can be used for an initial estimate
of the sound and vibration load. The actual
sound and vibration stress has to be estimated.
The times can be taken into account in the esti‐
mate when the electric power tool is switched off
and also when it is switched on but running with‐
out any load.
For information on compliance with the Physical
Agents (Vibration) Directive 2002/44/EC, see
www.stihl.com/vib.
English
measured in accord‐
pA
meas‐
WAd
49