State Of Charge; Leds On Battery; Assembling The Lawn Mower; Assembling The Grass Catcher Box - Stihl RMA 239.1 C Gebrauchsanleitung

English
refer to www.stihl.com/charging-times for charg‐
ing times.
► Charge the battery as described in the instruc‐
tion manual for the STIHL AL 101, 301, 500
charger.
6.2

State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.1.
There is a malfunction in the mower or battery.
7 Assembling the Lawn
Mower
7.1 Attaching the Handlebar
► Switch the lawn mower off and remove the
battery.
► Place the lawn mower on a level surface.
► Press sleeve (1) into the bores in upper han‐
dlebar (2).
► Fit spring washers (3) with the convex side
facing inwards onto sleeve (1).
32
80-100%
60-80%
40-60%
20-40%
► Guide upper handlebar (2) into handlebar
bracket (4).
0-20%
► Push bolt (5) through the bores in handlebar
bracket (4) and the sleeve in upper handle‐
bar (2).
► Place nut (6) in the notch in handlebar
bracket (4).
► Tighten bolt (5).
► Insert cable (7) in guide (8) and press into
holders (9 and 10).
► Fasten cable (7) to the handlebar using cable
clip (11).
The handlebar must not be dismantled again.
7.2
7.2.1
► Fit upper part of grass catcher box (1) onto
lower part of grass catcher box (2).

7 Assembling the Lawn Mower

Assembling, Attaching and
Detaching the Grass Catcher
Box

Assembling the Grass Catcher Box

0478-131-9630-A