Leds On Battery; Activating And Deactivating Bluetooth® Radio Interface; Assembling The Lawn Mower - Stihl Rma 443.3 Pv Gebrauchsanleitung

7 Activating and Deactivating Bluetooth® Radio Interface
6.3

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
20.1.
There is a malfunction in the mower or battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
7.3 Reset battery to the factory set‐
ting via a Bluetooth
face (AP 200.0 S, 300 S,
300.0 S, 500.0 S only)
Resetting the battery to the factory setting means
that all user-specific data will be deleted.
► Press the pushbutton four (4) times in quick
succession and keep it pressed on the fourth
time until the "BLUETOOTH
the symbol flashes blue.
► Then release the pushbutton immediately.
► Connect the battery to the STIHL connected
app and check whether all user-specific data
has been deleted.
0478-131-9670-B
Radio
®
®
radio interface:
symbol
®
®
radio interface:
symbol
radio inter‐
®
®
" LED next to
8 Assembling the Lawn
Mower
8.1 Assembling, Attaching and
Detaching the Grass Catcher
Box
8.1.1 Assembling the Grass Catcher Box
► Fit upper part of grass catcher box (1) onto
lower part of grass catcher box (2).
► Press pins (3) through openings (4) from the
inside.
► Press upper part of grass catcher box (1)
downwards.
The upper part of the grass catcher box
engages with a click.
8.1.2 Attaching the Grass Catcher Box
► Switch the lawn mower off.
► Place the lawn mower on a level surface.
► Open discharge flap (1) and hold it open.
► Take hold of grass catcher box (2) by han‐
dle (3) and attach to mounts (5) from above
using hooks (4).
► Set down discharge flap (1) on grass catcher
box (2).
8.1.3 Detaching the Grass Catcher Box
► Switch the lawn mower off.
► Place the lawn mower on a level surface.
► Open the discharge flap and hold it open.
► Remove the grass catcher box upwards by the
handle.
► Close the discharge flap.
English
43