Grease Separator Ns 15-25; Putting The Control Unit Into Operation - Kessel SE NS 2 Bedienungsanleitung

3.4.2

Grease separator NS 15-25

27
16
25
3.4.3

Putting the control unit into operation

• Connect the control unit to the power supply.
• Switch on at the main switch, initialisation starts automatically. While the LEDs light up for approx. 4 seconds,
the electrical components are checked and the menu
53) can then be carried out.
If the display does not show initialisation (menu 3.8.1. Language) the control unit has already been initialised. In
this case, the parameters set must be checked or the unit must be reset to the factory setting (
61, item 3.10, Reset). When the factory settings have been reset, initialisation of the control unit is automatical-
ly opened.
010-913
Installation
42 23
Ill. [8]
3.8.1. Language
52 / 108
82 30 35
81
82
is displayed. Initialisation ( 3.4.4 on page
➲
5.1 on page
➲
2017/10